PDF associated:
/SwayBarInstallationSheet_927100.pdf
Sway Bar Installation Sheet 927 100 ATTENTION Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part If you do not have a service manual or lack the skill to install this part it is recommended that you seek the services of a qualified technician Pay special attention to all cautions and warnings included in the shop manual Read and follow all instructions carefully 1 Raise vehicle and support properly 2 Remove left side tire for access to the Sway Bar 3 Support the engine cradle with a jack and lower the engine cradle by removing the two rear engine cradle bolts NOTE Refer to the shop manual s specific procedure concerning this step It is important to follow the procedure carefully to avoid damaging other components 4 Remove the original Sway Bar from the vehicle per the procedure outlined in the service manual 5 Slide the Sway Bar through the left side of the vehicle Make sure ends of bar are angled down NOTE Bar should match OE orientation See image below Image may vary depending on application 6 Install the Sway Bar links loosely on the Control Arm to support the bar NOTE Do not tighten the Sway Bar links at this time 7 Install the supplied bushings onto the Sway Bar 8 Install the provided U shaped brackets to the frame using the provided bolts Tighten to the specification found in the shop manual 9 Reinstall the left tire 10 Slowly lower the vehicle to the ground 11 Tighten provided Sway Bar link nut 23 Nm 17 ft lbs DISLAIMER Even though every attempt is made to ensure this information is complete and accurate it is impossible to account for all possible circumstances or situations Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do Automobiles can be hazardous to work on be sure to take all necessary safety precautions Failure to do so may result in property damage or personal injury Certain motor vehicle standards and performance requirements may apply to your motor vehicle such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature
