PDF associated:
/PT 60-0004.pdf
MS8166 PT 60 0004 CV DO s and DON Ts Don t Use pneumatic tools on driveaxle components You may damage threads or distort components Do Mark components prior to removal to assure proper referencing upon reinstallation Don t Remove both axles at the same time Alignment of side gears will be lost Do Use a torque wrench when installing axle nuts Don t Use a hammer on the threaded end of the shaft It will damage the core Do Handle ABS system CV axles with caution Damage to the ABS sensor ring can occur resulting in a non functional ABS system Don t Raise a vehicle on the frame contact lift without supporting the suspension Running the vehicle in gear without supporting the suspension may damage the CV joints Do Compare the replacement unit to the original to ensure the proper application Don t Ignore noises or vibrations It may lead to more serious problems Do Use caution when draining the transaxle fluid It may be hot and cause injury Don t Allow CV axles to hang unsupported Always support the disconnected end of the axle Do Inspect wheel bearings strut bearings and seals for wear and or damage prior to installation of the replacement axle Don t Reuse prevailing type hardware They cannot be reused Do Check the integrity of the motor transmission mounts and mounting hardware Broken mounts can affect drivetrain alignment and damage the CV assembly Don t Strike frozen axles with a hammer to remove them Use the proper axle press for the job Some things speak for themselves CARDONE Industries Inc 5501 Whitaker Ave Philadelphia PA 19124 1799 www cardone com 1 800 777 4304 BRAKES DRIVETRAIN ELECTRONICS MOTORS PUMPS STEERING REMANUFACTURED CV DRIVEAXLES Frost Sullivan is a leader in international strategic market consulting and training They present Market Engineering Awards to companies that demonstrate diligence perseverance and dedication in the global marketplace
