PDF associated:
/1989 Jeep Install Notice Cluth parts check.pdf
STOP - Important Notice
Clutch Pedal Assembly on Jeep Cherokee,
Commanche and Wrangler
Before replacing slave cylinder, master cylinder and clutch
components, please do the following:
1. Check the clutch pedal bracket assembly and master cylinder
rod for alignment and bracket wear.
2. Check the master cylinder for dark fluid and/or metallic
particles.
3. Additionally, check to make certain that the firewall and pedal
are not moving or flexing when the pedal is pushed down. This
flexing will cause similar conditions due to the pedal rod’s
angle of entry into the bore.
If you find either dark fluid or metallic particles, the clutch
pedal bracket must be repaired or replaced.
Failure to make this examination and repair may void your
warranty.
Note: It is important to examine the clutch pedal bracket when replacing clutch hydraulic
components. Failure of any of these components is often related to a worn clutch pedal
bracket that results in misalignment between the pedal rod and the master cylinder body.
This misalignment results in scuffing and wear of the master cylinder bore. Metallic
particles generated from this condition then migrate to the slave cylinder seal, resulting in
slave cylinder wear.
99999019
