PDF associated:
/PT 40-0003.pdf
JDA3090 PT 40 0003 Wiper Motor Bench Test for 40 169 GM vehicles using wiper motor 40 169 Determining if the wiper motor and pulse board are good Follow the bench test procedure below to test the motor and pulseboard Step 1Connect battery ground to motor housing and terminal T1 Do not disconnect for all steps Step 2Connect 12 volts 15 amp source minimum to terminal T2 Motor runs low speed Step 3Disconnect 12 volts from terminal T2 and connect to terminal T3 Motor runs high speed NOTE If motor does not run in step 1 or 2 check pulseboard contacts If contacts are good replace the pulseboard Step 4Disconnect 12 volts from terminal T3 and connect to terminal T4 Using a jumper wire connect terminals T2 and T5 Motor runs and parks Application Problem Solution T5 T3 T1 T4 T2 View of connector end with locking tab at top T1 through T5 represent connector spade terminal positions Window Lift Motors Re engineered to perform better than new CARDONE s Motors coverage includes Window Lift Gear Kits Window Lift Motors Wiper Motors O E Gaskets CARDONE through extensive engineering research has found that O E gaskets are often weak and are the cause of motor failure CARDONE remanufactures all of its Window Lift Motors with a top quality gasket as a replacement for the O E gasket The strength of the gasket ensures the unit will be protected in all situations This saves the customer time and money from unnecessary repairs 12 month 18 000 mile warranty Contact your local auto parts store or visit our web site www cardone com for more information on this and other CARDONE products today
