A1 Auto Parts
325-235-2420
a1auto@a1-autoparts.com
10525 S IH 20
Sweetwater
TX 79556



PDF associated: /PT 22-0003.pdf
JD8051 PT 22 0003 Loosening Boot Clamps Before Alignment Prevents Damage All vehicles with power and manual Rack Pinion Steering Systems Premature boot bellows failure allowing contamination i e water sand dirt to enter the Rack and Pinion damaging internal components Boots twisted during front end alignment adjustments 1 Remove outer boot clamp 2 Perform front end alignment 3 Make sure boot seam is straight not twisted and boots are in the proper groves 1 8 groove for plastic hard boot and groove for rubber soft boot 4 Install outer boot clamp The boots must be inspected after an alignment performed Twisted boots will lead to premature failure and VOID THE WARRANTY Problem Application Cause Solution Note





Copyright A1 Auto Parts.

Payments listed can only be used for products in your cart.
These payments can not be used to pay for services at our physical store.
Our store location Accepts
  • Cash
  • Debit or Credit Card
    We do not accept American Express
    (Only when the card it self is physicaly present and the person who was issued the card is using it and showing proper identification)
  • Check
    (Only when the account is drawn on a bank located in Nolan County Texas USA and the owner of the account is present with proper id and physically lives in Nolan county Texas USA)
    •  Pay with PayPal, PayPal Credit or any major credit card