PDF associated: /PT 22-0001.pdf

---

JDA7268 PT 22 0001 What Causes Binding in the Steering System Binding poor returnability noise no assist to either or both sides vibration or leaks Contamination from defective components or hoses is blocking fluid flow through the spool valve of the steering unit When replacing any steering component it is recommended that power steering lines be replaced if more than 4 years old or appear damaged Also flush the entire system with new fluid to wash away any contaminates If you do not flush the system and replace lines you could experience a return of the symptoms Failure to properly service the power steering system will VOID THE WARRANTY Some manufacturers recommend an annual change of the power steering fluid to increase the longevity of the system Be sure to check any steering or suspension component that may be placing an abnormal load on the system Check steering input shaft coupler outer tie rods ball joints and upper strut mount bearings if so equipped CARDONE Industries recommends that you use a power steering filter when Power Steering components are replaced Problem Cause Solution Note CAUTION DO NOT USE TEFLON TAPE ON THE FITTINGS