A1 Auto Parts
325-235-2420
a1auto@a1-autoparts.com
10525 S IH 20
Sweetwater
TX 79556



PDF associated: /PT 20-0015.pdf
MS0032 PT 20 0015 Improper Placement of Fitting O ring Results in No Pressure All vehicles equipped with power steering No pressure output from power steering pump after installation of a new O ring on the power steering pressure fitting Incorrect placement of O ring on the pressure fitting blocking the flow of fluid from the bypass hole to the flow control valve This causes a no pressure condition Install the replacement O ring in the correct position on the fitting Also make sure piston is moving freely in bore a stuck piston will cause the same problem See instruction sheet 93 0347 20 Application Problem Note Solution Cause Correct O ring location NOTE Make sure bypass hole is open Do not install O ring here





Copyright A1 Auto Parts.

Payments listed can only be used for products in your cart.
These payments can not be used to pay for services at our physical store.
Our store location Accepts
  • Cash
  • Debit or Credit Card
    We do not accept American Express
    (Only when the card it self is physicaly present and the person who was issued the card is using it and showing proper identification)
  • Check
    (Only when the account is drawn on a bank located in Nolan County Texas USA and the owner of the account is present with proper id and physically lives in Nolan county Texas USA)
    •  Pay with PayPal, PayPal Credit or any major credit card