PDF associated:
/742-601-TN.pdf
1 Disclaimer Even though every attempt is made to ensure this information is complete and accurate it is impossible to account for all possible circumstances or situations Please consult with a qualifi ed auto technician before attempting to perform any work you are not qualifi ed to do Automobiles can be hazardous to work on be sure to take all necessary safety precautions Failure to do so may result in property damage or personal injury Certain motor vehicle standards and performance requirements may apply to your motor vehicle such as Federal Motor Vehicle Safety Standards by the National Highway Traffi c Safety Administration Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature ATTENTION Refer to the appropriate shop manual for your vehicle to obtain specifi c service procedures for this part If you do not have a service manual or lack the skill to install this part it is recommended that you seek the services of a qualifi ed technician Pay special attention to all cautions and warnings included in the shop manual Read and follow all instructions carefully 742 601 TECH NOTES WINDOW LIFT MOTOR Various Model Cars Trucks 1987 2005 This window lift motor is intended to fi t multiple applications A direct fi t plug is included that will interface with the most popular vehicles If the window lift motor that you are replacing has a connector that does not match the one included you will need to splice the original connector to the wires of the new motor Simply cut the vehicle side of the connector off from the provided pigtail making sure to leave enough wire attached Using butt connectors splice in needed pigtail from original motor making sure that the polarity is correct in order for the switch to operate properly Nissan Motor Application Note If one or more threaded mounting holes on the motor that you are replacing are in a diff erent position on the new motor you will need to move the threaded insert to the correct location Follow instructions below Removal STEP 1 From the back side of the motor square gear facing away from you bend the two metal tabs outward that secure the backing plate to the motor Remove the metal backing plate This will give you the clearance necessary to move the insert STEP 2 From the front side of the motor thread an M6 bolt partially into the insert Use a hammer to tap the metal insert out of the plastic retainer Be careful not to break the plastic ear off of the motor STEP 3 To install the insert unscrew the bolt from the insert and thread it back into the insert from the other direction Tap the insert into the correct hole Make sure to support the plastic ear that it does not break STEP 4 Replace the metal backing plate making sure to bend the metal tabs fi rmly into position with a hammer and a punch
